Biomechanical differences of three cephalic fixation methods for patients with basilar invagination and atlantoaxial dislocation in the setting of congenital atlas occipitalization: a finite element analysis.
Case Report
In cases of basilar invagination-atlantoaxial dislocation (BI-AAD) complicated by atlas occipitalization (AOZ), the approach to cranial end fixation has consistently sparked debate, generally falling into two categories: C1-C2 fixation and occipitocervical fixation. Several authors believe that C1-C2 fixation carries a lower risk of fixation failure than occipitocervical fixation./r/nTo study the biomechanical differences among 3 different cranial end fixation methods for BI-AAD with AOZ./r/nThis was a finite element analysis./r/nA 35-year-old female patient diagnosed with congenital BI-AAD and AOZ./r/nrange of motion (ROM), peak von Mise stress (PVMS), cage micro-subsidence, cage micro-slippage./r/nFour finite element models were constructed, including unstable group (BI-AAD with AOZ), C1 lateral mass screw group, occipital plate group, occipitocervical rod group. The flexion and extension (FE), lateral bending (LB) as well as axial rotation (AR) were simulated under a torque of 1.5 Nm. Parameters include C1-C2 ROM, PVMS on screw-rod construct, cage micro-subsidence, cage micro-slippage./r/nThe ROM of the C1 lateral mass screw group was smaller than that of the other fixation groups in LB and AR, but not FE. Compared with the occipitocervical rod group, the ROM in LB and AR of the occipital plate group was higher, but not in FE. The PVMS of C1 lateral mass screw group was significantly higher than that of the other groups. The ROM and PVMS of the occipitocervical rod group were in between the other 2 groups. Regarding the screws at the cranial end, the PVMS of the 4-screw occipitocervical rod group was significantly lower than that of the other groups. In general, the cage micro-motion follows the ascending order: C1 lateral mass group < occipitocervical rod group < occipital plate group./r/nIn cases of BI-AAD with AOZ, the C1 lateral mass screw group provided the least ROM and cage micro-motion, but the screw-rod PVMS was the largest. The advantage of occipital plate fixation lies in the lowest screw-rod PVMS, but the ROM and cage micro-motion is the highest. Four-screw fixation at the cranial end of occipitocervical rod group helps to reduce the PVMS and may prevent screw failure at the cranial end.
